When your drain starts backing up, the first and most important thing to do is stop using the affected drain and any other drains connected to it. Because every litre of water you send down a blocked line makes the situation worse, increases the risk of overflow, and potentially turns a simple clearing job into a sewage backup emergency.
If only one drain is slow, the problem is likely localised and manageable. If multiple drains, toilets, or fixtures are backing up simultaneously, you are almost certainly dealing with a main sewer line blockage that needs an emergency plumber in Melbourne called immediately.
Here's what you need to do when your drains start backing up.
If your kitchen sink is backing up, don't run the dishwasher, don't run the laundry (the laundry drain may share the same line), and don't run any other sink that drains to the same branch line.
If your toilet is backing up or multiple fixtures are affected, stop using every water outlet in the property, such as taps, showers, dishwasher, washing machine. Turn off the washing machine mid-cycle if it's running. The main sewer line carries everything from every fixture, and nothing going in can get out while it's blocked.
The only exception: If you need to flush the toilet for health or hygiene reasons, do so once and monitor carefully. Do not flush repeatedly hoping to clear the blockage.
Run a small amount of water at another nearby fixture. A different sink, the bath, the laundry. If those all drain normally, your problem is isolated to the one drain.
If two or more fixtures are draining slowly or backing up at the same time or if using one fixture (running the kitchen tap, flushing the toilet) causes a reaction at another fixture (gurgling from the shower drain, water rising in the bathtub). You have a main sewer line problem.
This is the emergency scenario. Stop using all water immediately. Skip to Step 4 and call My Plumbing Services on 03 9071 4424 right now.
For a sink or basin: Use a flat-bottomed cup plunger. Block the overflow opening (the small hole near the top of the basin) with a wet cloth to prevent the suction from escaping through the overflow. Place the plunger over the drain opening, press down to create a seal, then work it firmly up and down 10–15 times. Lift to see if the water drains. Repeat several times before concluding it's not working.
For a toilet: Use a flange plunger. The one with the extended rubber lip that fits into the toilet drain opening. Insert the flange into the drain, create a seal with the cup against the toilet bowl, and work firmly up and down. Do not plunge aggressively if water is already close to the rim, the last thing you need is an overflow.
When to stop plunging: If 3–4 rounds of firm plunging produce no improvement, the blockage is either too solid, too far down the pipe, or a symptom of a structural pipe problem. Stop and call a Melbourne plumber. Continued aggressive plunging can damage older pipe connections.
For shower and floor waste drains, remove the drain cover and clear any visible accumulation of hair, soap scum, and debris from the top of the drain trap.
Here's when to call our plumber Melbourne right now.
Every minute a blocked drain sits without proper attention is another minute the situation can worsen. Call My Plumbing Services now for fast, professional, and honest service all the time.

